Outbound Smarthost setup - Exchange 2003 - 知識庫

知識庫

Included below are the instructions to configure a smarthost on Exchange 2003. Please note these instructions are provided "as-is" as Data102 does not directly support Microsoft Exchange. For further assistance please consult the Microsoft TechNet Library.

INSTRUCTIONS/PROCEDURE

1) Open Exchange System Manager on the Exchange Server
2) Open the Protocols folder in the Administrative Groups area
3) Open the SMTP folder
4) Right-click on the SMTP Virtual Server and select Properties
5) Select Advanced in the SMTP Virtual Server Properties
6) Enter your smarthost address in the smart host box. Click OK and exit.
7) Select the Routing Groups folder. This is usually located under Administrative Groups.
8) Select Connectors
9) Right-click the SMTP Connector and select Properties
10) On the General tab locate the radio button titled “Use DNS to route each address space on this connector”
11) Select the radio button that says “Forward all mail through this connector to the following smart hosts”
12) Enter your smart host address. Click OK to save.

ADDITIONAL DETAILS

Smarthost addresses for all of our sites are included below.

United States: outbound.directmx.com

Please allow 20 to 30 minutes for the mail to find the new outbound route. If you have recently configured the smarthost or outbound servers page on the control console, a delay may occur before messages begin routing to the smarthost.

Should you have additional questions, please call us or open a ticket for additional assistance.

知識庫

分類

分類

Outbound Smarthost setup - Exchange 2003

相關文章

標籤雲

技術支援

知識庫

分類

分類

Outbound Smarthost setup - Exchange 2003

相關文章

標籤雲

技術支援

Generate Password